Labconco* CentriVap DNA Systems

.Epoxy-coated steel housing with injection-molded
thermoplastic control panel
.Acrylic lid
.Lid latch with safety sensor
.Phenol-free lid gasket
.Epoxy-coated aluminum chamber
.300 watt heater
.Microprocessor-controlled programming for run
time from 1 to 999 minutes, heat from OFF to
HI (100°C) in one degree increments and heater
time from 1 to 999 minutes. Memory stores
1 to 9 programs.
.LCD for display of program number, actual and
set point temperature, heater time remaining
and run time remaining
.Control panel with RUN/STOP button,
PREHEAT button, set point SELECT
button, increase/decrease buttons, and
3 Quick-Start buttons
.Centrifugal motion is provided by a brushless
motor capable of achieving up to 1725 rpm.
.Quick-Stop System to stop vacuum pump,
open valve to bleed air into the chamber and
stop the rotor within seconds after time expires
or RUN/STOP button is pressed
.Built-in diaphragm pump achieves vacuum of
29.6 in. Hg and has displacement capacity of 34
liters per minute. All wetted parts are Teflon or
Teflon-coated.
.Automatic vacuum release valve
.Built-in vacuum delay allows rotor to achieve speed before applying vacuum.
.Audible alarm to signal completion of set point run time.
.Two 177 milliliter glass traps
.Includes DNA Rotor 74629-00
.A 6.5 foot, 3 wire cord and plug is provided on 115 volt model.
.A 9.8 foot cord is provided on 230 volt model. An electrical plug is required.
.ETL and ETL-C listing on 115 volt, 60 Hz model
.CE mark on 230 volt, 50/60 Hz model.
.Overall dimensions with closed lid: 13.75 in. Wide x 26.1 in. Deep x 11.2 in. High (34.9 x 66.3 x 28.4 cm)
.Actual weight 69 lbs. (31 kg). Shipping weight 75 lbs. (34 kg)